Brake Switch (Cruise Control): Service and Repair

REMOVAL
1. Remove lower steering column cover and knee blocker panel from instrument panel.
2. With the pedal fully depressed, rotate the stop lamp switch counter clockwise 27 degrees and remove switch from the mounting bracket.
3. Disconnect wire connector from stop lamp switch by depressing the lock tabs holding stop lamp switch to mounting bracket and remove switch.

INSTALLATION
1. Connect the blue harness connector to the stop lamp switch.
2. While depressing the brake pedal, insert switch into the keyed hole in the bracket and rotate the switch into the locked position.
3. Gently pull back on the brake pedal until the pedal will go no further. This will cause the switch plunger to ratchet backward to the correct position. No further adjustment is necessary