NOTE: Bolts that have thread sealer or torque lock patches should not be reused. Always install new bolts in these applications.
| Back-up Lamp Switch | 18 Foot Pound-Force (ft.lb) |
| Crossover Cable Adj. Screw | 70 Inch Pound-Force (in.lb) |
| Drain Plug | 267 Inch Pound-Force (in.lb) |
| Differential Ring Gear Bolts | 60 Foot Pound-Force (ft.lb) |
| Dust Shield to Transaxle | 105 Inch Pound-Force (in.lb) |
| End Plate Cover Bolts | 21 Foot Pound-Force (ft.lb) |
| Front Engine Mount to Trans | 80 Foot Pound-Force (ft.lb) |
| Front Mount Through Bolt | 45 Foot Pound-Force (ft.lb) |
| Front Mount to Engine Bolt | 40 Foot Pound-Force (ft.lb) |
| Lateral Bending Strut to Engine | 40 Foot Pound-Force (ft.lb) |
| Lateral Bending Strut to Trans | 40 Foot Pound-Force (ft.lb) |
| Left Mount Through Bolt | 80 Foot Pound-Force (ft.lb) |
| Left Mount to Transaxle | 40 Foot Pound-Force (ft.lb) |
| Output Bearing Race Ret. Strap | 96 Inch Pound-Force (in.lb) |
| Power Hop Damper Bkt. to Trans | 40 Foot Pound-Force (ft.lb) |
| Power Hop Damper to Frame Bkt | 40 Foot Pound-Force (ft.lb) |
| Power Hop Damper to Trans. Bkt | 40 Foot Pound-Force (ft.lb) |
| Reverse Fork Bracket | 96 Inch Pound-Force (in.lb) |
| Reverse Idler Shaft Bolt | 19 Foot Pound-Force (ft.lb) |
| Shift Cable Bracket to Transaxle | 250 Inch Pound-Force (in.lb) |
| Transaxle Case Bolts | 21 Foot Pound-Force (ft.lb) |
| Transaxle to Engine Bolt | 70 Foot Pound-Force (ft.lb) |
| Trans. to Eng. Intake Bkt. Bolts | 70 Foot Pound-Force (ft.lb) |
| Vehicle Speed Sensor | 60 Inch Pound-Force (in.lb) |
| Vertical Bending Strut to Engine | 80 Foot Pound-Force (ft.lb) |
| Vertical Bending Strut to Trans | 80 Foot Pound-Force (ft.lb) |