Rear

NOTE: Before proceeding with this procedure, review applicable Service Precautions.

REMOVAL
1. Raise the vehicle.
2. Remove the tire and wheel assembly from the vehicle.






3. Disconnect the wheel speed sensor cable connector from the vehicle wiring harness. Remove the clip attaching wheel speed sensor cable connector to the vehicle's body.
4. Remove the wheel speed sensor cable routing bracket from under rear brake flex hose mounting bracket. Then remove the speed sensor cable from the routing clips on the rear brake flex hose and chassis brake tube.
5. Remove the bolt attaching the wheel speed sensor cable routing bracket to rear strut.

CAUTION: When removing a wheel speed sensor from the rear disc brake adapter, do not use pliers on the sensor head. This may damage the sensor head. If the sensor has seized, use a hammer and a punch to tap the edge of the sensor head ear, rocking the sensor side-to-side until free.






6. Remove the bolt attaching the wheel speed sensor to the rear disc brake adapter, then carefully remove the sensor head from the rear disc brake adapter and vehicle.

INSTALLATION

CAUTION: Failure to install speed sensor cables properly may result in contact with moving parts or an over extension of cables causing an open circuit. Be sure that cables are installed, routed, and clipped properly.

1. Install the wheel speed sensor head into the disc brake adapter.
2. Install the wheel speed sensor mounting bolt. Tighten the mounting bolt to a torque of 12 Nm (105 inch lbs.).
3. Install the wheel speed sensor cable routing bracket on the rear strut.
4. Install wheel speed sensor cable into the routing clips on the rear brake hose and brake tube.
5. Connect the wheel speed sensor cable connector into vehicle wiring harness. Install the clip attaching the wheel speed sensor cable connector to vehicle's body.
6. Install the tire and wheel assembly on vehicle.
7. Lower the vehicle.
8. Road test the vehicle to ensure proper operation of the base brakes and ABS.