Selector Lever

The selector lever is retained to the shaft by two roll pins (one inside the other).

REMOVAL

Fig. 33:

1. Disconnect the selector cable from the selector lever (Fig. 33) and remove from cable bracket.
2. Using a pin punch, remove both roll pins from the lever.
3. Pull up and remove the selector lever from the transaxle selector shaft.

INSTALLATION

Fig. 34:

1. Install the selector lever to the shaft and fasten with two NEW roll pins. Refer to (Fig. 34) for correct roll pin orientation.
2. Install selector cable to cable bracket and install clip. Install cable to selector lever.