Gearshift Boot

REMOVAL
1. Pull shifter boot down and away from shifter knob.

Fig. 7:

2. Push down on knob and rotate clockwise to remove (Fig. 7).

Fig. 8:

3. Remove the center console assembly as shown in (Fig. 8).

Fig. 9:

4. Separate shifter boot from shifter assembly (Fig. 9). Boot is retained to shifter by three push-pin retainers.

INSTALLATION
1. Install boot to the shifter assembly (Fig. 9). Fasten boot to shifter with the three retainers.
2. Install center console assembly (Fig. 8). Verify that boot is not pinched at console opening before tightening.

Fig. 10:

3. Install knob to shifter lever, align knob to three o'clock position, push knob down to engage spring and rotate counter clockwise (Fig. 10).
4. Return shifter boot to its original position (seated around knob lip).