Windshield Washer Pump: Service and Repair

REMOVAL
1. Raise vehicle on hoist.
2. Disconnect the wire connector from the reservoir pump.
3. Disconnect the washer hose at the pump and drain the reservoir.

Windshield Washer Pump Remove/Install:

4. Gently pry pump away from reservoir and out of grommet. Care must be taken not to puncture reservoir.
5. Remover rubber grommet from reservoir. If replacing the pump, discard the old washer pump grommet. If replacing the reservoir only, reuse the old washer pump grommet.

INSTALLATION
For installation, reverse the above procedures. Make sure to use new grommet when installing new washer pump.