DTC 22

Chart - Code 22 Throttle Position Sensor (Signal Voltage Low):

Wiring Diagram for Throttle Position Sensor Circuit.:

CODE 22 - THROTTLE POSITION SENSOR (TPS) CIRCUIT (SIGNAL VOLTAGE LOW)


Circuit Description:
The Throttle Position Sensor (TPS) provides a voltage signal that changes relative to the throttle blade. Signal voltage will vary from about .5 at idle to about 5 volts at Wide Open Throttle (WOT). The TPS signal is one of the most important inputs used by the Electronic Control Module (ECM) for fuel control and for most of the ECM control outputs.


Test Description:Numbers below refer to circled numbers on the diagnostic chart.
1. Code 22 will set if engine running, TPS signal voltage is less than about .2 volt for 3 seconds.
2. Simulates Code 21: (high voltage) If the ECM recognizes the high signal voltage the ECM and wiring are OK.
3. TPS adjustment: With throttle closed, the TPS voltage reading should be .54V +/- .08V.
4. This simulates a high signal voltage to check for an open in CKT 417.


Diagnostic Aids:

A "Scan" tool reads throttle position in volts. Should read .54V +/- .08V with throttle closed and ignition "ON" or at idle. Voltage should increase at a steady rate as throttle is moved toward WOT. An open or short to ground in CKTs 416 or 417 will result in a Code 22. Refer to "Intermittents" in DIAGNOSIS BY SYMPTOM - NO TROUBLE CODE STORED.