C: Starter Enable Relay Test

C: Starter Enable Relay Test






C2. Connect a fused jumper between terminals E (YEL) wire and A (DK GRNIWHT) wire of the Starter Enable Relay Connector. Turn Igriition Switch to START.
- If engine cranks proceed to C3.
- If engine does not crank go to diagnosis of Starter and Charging Circuits
C3. Reconnect the Starter Enable Relay and connect a fused jumper from terminal A3 (DK GRN) wire of the PASS Key Decoder Module to ground. Turn Ignition Switch to START.
- If engine cranks, replace the PASS Key Decoder Module.
- If engine does not crank, check the DK GRN (965) wire for an open. If wire is OK, replace the Starter Enable Relay.