Security Indicator Operation

The PASS-Key(R) II system controls the "SECURITY" indicator. In normal operation, the PASS-Key(R) 11 module controls the lamp only when the ignition is ON. There are four PASS-Key(R) II system bulb modes as follows.
1. Bulb Check. When the ignition is first turned on, the SECURITY" indicator illuminates for approximately five seconds to indicate the system is operating correctly. Refer to the following bulb symptoms, if the bulb check does not operate.
2. Bulb Stays Illuminated and Engine Starts. If the "SECURITY" indicator stays illuminated after the engine starts, this is an indication that the PASS-Key� II module is reading an open, short or incorrect resistance value. Verify that the PASS-Key� II module connection at the base of the steering column is properly connected and that a good ignition key is being used.
3. Bulb Stays Illuminated and Engine Does Not Start. If the "SECURITY" indicator stays illuminated while and after attempting to start the engine and the engine does not crank or start, this indicates that the PASS-Key� II module has sensed an improper key value and has disabled the engine and set the disable timer. This specifically does not mean that the key sense circuit is open or shorted to chassis ground, refer to "Bulb Flashes and Engine Does Not Start." Testing and Inspection Remove the key from the ignition and verify that is the correct key code for the vehicle. The key code may be checked using J 35628-A and comparing the key code to that of other keys for the vehicle. After waiting approximately 3 minutes for the disable time to expire and the "SECURITY" indicator to go out, try to start the engine with a known good key with the proper key code.
4. Bulb Flashes and Engine Does Not Start. If the "SECURITY" indicator flashes once per second and the engine does not start, this indicates that the PASS-Key� II module sensed an open, a short or otherwise invalid (value matched none of the available 15 key codes) input from the ignition key resistor input. The PASS-Key� II module does not start the disable timer during this operation mode. This operation mode could also be caused by a malfunctioning power or ground circuits.