Turn Lamps

With the ignition switch in RUN, BULB TEST or START, voltage is applied from I/P Fuse Block SIG/BU/PS BTSI/COR Fuse 1B ,through the turn flasher to the normally closed switch in the Turn/Hazard Switch . With the Turn Switch in LEFT turn position, voltage is applied through the Turn switch and through two paths to the lamps One path is through LH front Park/Turn lamps and the Side marker lamps. The second path is applied through the L/H Tail/Stop/Turn/Lamps. The lamps go on immediately. They begin to flash when the current heats up the timing element in the flasher and the flasher repeatedly opens and closes the circuit. A similar procedure is followed when the Turn Switch is in the RIGHT turn position.