Operation CHARM: Car repair manuals for everyone.
Home >> Pontiac >> 1997 >> Bonneville V6-3.8L SC VIN 1 >> Repair and Diagnosis >> Transmission and Drivetrain >> Automatic Transmission/Transaxle >> Specifications >> Mechanical Specifications >> 4T65-E Automatic Transaxle >> End Play Specifications >> Input Clutch Housing End Play Check

Input Clutch Housing End Play Check

^ Tools Required:
- J 26958 Output Shaft Loading and Aligning Tool
- J 26958-10 Adapter Plug
- J 33381-A Final Drive Remover and Installer
- J 33386 Input Shaft End Play Tool
- J 38385 Output Shaft Loading Tool Adapter






1. Adjust the collar on J 33381-A to 4T60-E CLUTCH & DRUM.





2. Install J 33381-A into the input clutch housing assembly(632).
3. Tighten the threaded rod of J 33381-A until the rod is finger tight.
4. Use J 33381-A in order to lift the input clutch housing assembly (632). The sprag clutch assemblies will also be attached.
5. Install the assembly (632) into the case. Be sure that the assembly is down all the way.
6. Remove J 33381-A from the assembly.





7. Install J 26958, J 26958-10, and J 38385 Onto the case extension (6), if you have not yet installed these tools.





8. Using two bolts, install J 33386 onto the case.
9. Tighten the bolts in order to securely hold J 33386.
10. Tighten J 26958 finger tight in order to eliminate differential carrier end play.





11. Insert the thrust washer (630) from the input clutch housing into J 33386 as indicated. If the thrust washer will not fit into J 33386, select the next size smaller thrust washer and recheck.
12. Use a feeler gage in order to measure the clearance between J 33386 and the thrust washer (630):
^ If the clearance is less than 0.0521 mm (0.006 in), use the current size thrust washer.
^ If the clearance is 0.0521 mm (0.006 in) or more, select the next size larger thrust washer and recheck.
13. Remove J 33386.
14. Adjust the collar on J 33381-A to 4T60-E CLUTCH & DRUM. Make sure that the threaded rod is fully loosened.
15. Install J 33381-A into the input clutch housing (632).
16. Tighten the threaded rod of J 33381-A until the rod is finger tight.
17. Use J 33381-A in order to lift the input clutch housing assembly (632). The spray clutch assemblies will also be attached.
18. Remove the assembly (632) from the case.
19. Position the transmission so that the oil pan is facing down.
20. Remove J 26958, J 26958-10, and J 38385.
pro multis · About Operation CHARM