Radio Operation

ETR AM/FM Stereo/Cassette:

VOLUME KNOB
Press the "VOLUME" knob to turn the radio on or off. Rotate the knob to adjust sound.

"AM/FM"
Press "AM/FM" to receive either AM, FM1, or FM2. The lighted display shows the selection.

TUNE KNOB
Press the "TUNE" knob lightly to release the knob. mm the knob to choose desired radio stations. Press the "TUNE" knob back in to store it when not in use.

"RECALL"
Press "RECALL" to recall the station being played or the clock display. Press "RECALL" also to display the time when the ignition is off.

"SEEK"
Press "SEEK V or &" and the radio will tune to the next lower or higher station and stay there.

CLOCK
To set the clock display on the radio, the ignition may be "ON" or "OFF". To set the clock:
1. Press and hold "HR" (hour) until the correct hour appears.
2. Press and hold "MIN" (minute) until the correct minute appears.

There will be a two-second delay before the clock goes into the time-set mode.

PUSH BUTTONS
To preset six AM stations and six FM1 stations and six FM2 stations:
1. Press the "AM/FM" button to select AM, FM1, or FM2.
2. Tune in desired station.
3. Press and hold one of the six push buttons until the display shows "SET." Whenever pressing that button, the preset station will return.

Repeat these steps for each push button.

SPEAKER ADJUSTMENT
Balance Knob
Press "BAL" knob lightly to release the knob. Turn the knob to move the sound between the right and left speakers. Press "BAL" knob back in to store it when not adjusting.

Fade Knob
Press "FADE" knob lightly to release the knob. Turn the knob to move the sound between the front and rear speakers. Press "FADE" knob back in to store it when not adjusting.

STEERING WHEEL CONTROLS
Vehicles equipped with this radio have steering wheel controls for the audio system. With steering wheel controls, use the buttons on the steering wheel to:
^ Play the cassette tape player.
^ Adjust the volume.
^ Choose AM, FM1 or FM2.
^ Use the "SEEK" and "MUTE" functions.
^ Choose one of the preset stations.

SETTING THE GRAPHIC EQUALIZER
Use the levers to set the bass, midrange and treble until you get the sound you want. The 40, 100, 250 and 625 levers adjust the bass; 1.6K is midrange, and 4K and 12K control the treble. The 1.6K lever may be set in the middle position and then the other levers may be moved up or down until a satisfactory amount of bass and treble is achieved.