Steering Wheel Horn Switch

REMOVE OR DISCONNECT
1. Inflatable restraint steering wheel module. Refer to "Inflatable Restraint Steering Wheel Module".
2. Horn wiring connector from steering column.
3. Bolts/screws (38).
4. Horn switch (52) from steering wheel (2).

INSTALL OR CONNECT


NOTICE: Always use the correct fastener in the correct location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and the joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

1. Position horn switch (52) to steering wheel (2).
2. Bolts/screws (38).
^ Tighten bolts/screws (38) to 1.9 Nm (17 inch lbs.).
3. Horn wiring connector to steering column.
4. Inflatable restraint steering wheel module. Refer to "Inflatable Restraint Steering Wheel Module".