Low Traction Indicator Inoperative

CIRCUIT DESCRIPTION
The LOW TRAC Indicator is controlled by the EBTCM. The LOW TRAC Indicator is activated during a traction control event only. When the EBTCM detects a low traction condition it supplies a ground for CKT 1656 turning on the LOW TRAC Indicator.

DIAGNOSTIC AIDS
^ It is very important that a thorough inspection of the wiring and connectors be performed. Failure to carefully and fully inspect wiring and connectors may result in misdiagnosis, causing part replacement with reappearance of the malfunction.
^ Thoroughly inspect any circuitry that may be causing the complaint for the following conditions:
- Backed out terminals
- Improper mating
- Broken locks
- Improperly formed or damaged terminals
- Poor terminal-to-wiring connections
- Physical damage to the wiring harness

^ The following conditions may cause an intermittent malfunction:
- A poor connection
- Rubbed-through wire insulation
- A broken wire inside the insulation

^ If an intermittent malfunction exists refer to General Electrical Diagnosis Procedures in Diagnostic Aids for further diagnosis.

TEST DESCRIPTION
The number(s) below refer to the step number(s) on the diagnostic table.
2. This step checks for an internal EBTCM malfunction.
4. This step checks for an open in CKT 1656.