Wiper Switch: Service and Repair
Assembly Procedure1. Install the pivot and pulse switch assembly to the lock housing cover and sleeve assembly.
2. Lubricate the switch actuator pivot pin (2) with lithium grease.
3. Install the switch actuator pivot pin (2) into the pivot and pulse switch assembly (1) and the lock housing cover and sleeve assembly.
Important: Use care not to damage the wires when pulling the pivot and pulse switch assembly wire harness through the steering column.
4. Pull the pivot and pulse switch assembly wire harness through the steering column.
5. Install the pivot and pulse switch assembly connector to the bulkhead connector.
6. Install the wire protector shield.
7. Install the lock housing cover and sleeve assembly. Refer to Lock Housing Assembly-Assemble-Off Vehicle under Steering Column Service and Repair.