Fog/Driving Lamp Switch: Service and Repair
FOG LAMP SWITCH REPLACEMENT - FRONTREMOVAL PROCEDURE
1. Remove the instrument panel cluster trim plate.
2. Grasp the foglamp switch and pull firmly to release the retaining tabs from the IP carrier.
3. Disconnect the electrical connector from the foglamp switch.
4. Remove the foglamp switch from the vehicle.
INSTALLATION PROCEDURE
1. Connect the electrical connector to the foglamp switch.
2. Position the fog lamp switch to the retainers in the instrument panel carrier.
3. Install the foglamp switch to the instrument panel carrier pressing into place until fully seated.
4. Install the instrument panel cluster trim plate.