Ignition Relay: Testing and Inspection

CIRCUIT DESCRIPTION
The ignition relay supplies battery positive voltage to the following components:
^ Fuel injectors
^ Ignition control module
^ Heated oxygen sensors (HO2S)
^ A/C CLU relay
^ Mass air flow sensor
^ Evaporative emission (EVAP) solenoid
^ Air pump relay
^ Transmission solenoids

DIAGNOSTIC AIDS
If the ignition relay fails to close:
^ Engine will crank, but does not run.
^ Instrument panel lights will illuminate.
^ Scan data will be available.

TEST DESCRIPTION

Steps 1-4:

Steps 5-11:

The numbers below refer to the step numbers on the diagnostic table.
2. This step is testing the battery positive voltage circuit of the ignition relay.
3. This step is testing the ignition 1 positive voltage circuit of the ignition relay.
4. This step is testing the coil ground circuit of the ignition relay.
5. This step isolates the circuit from the ignition relay. All of the circuits at the relay are good if the test lamp illuminates.