Wiring Harness: Service and Repair

Wiring Harness Replacement

Removal

Tools Required
^ J41101 Pass-Through Connector Remover





1. Remove the transmission side cover.
2. Remove the control valve body.





3. Push the J41101 onto the pass-through connector from the outside of the transmission case in order to compress the pass-through connector,s retaining tabs.
4. With the retaining tabs compressed, use a screw driver in order to remove the pass-through
5. Remove the wiring harness (11)

Installation Procedure





Connect the wiring harness assembly to the following components:
^ The TFP switch assembly (13)
^ The pressure control solenoid (312) (red Connector)

Important

The 1-2 shift solenoids wires are red and light green. The 2-3 shift solenoid wires are red and yellow.

^ The 1-2 shift solenoid (305) (white connector)
^ The 2-3 Shift Solenoids (305) (White connectors)
^ The TCC solenoid (335)
^ Install the control valve body.
^ Install the transmission side cover.