Trim Plate Replacement - Front Floor Console

Trim Plate Replacement - Front Floor Console (Aztek)

Removal Procedure





1. Remove rear cup holder liner and remove the screw.
2. Pull up on the trim plate to release the retainer clips.
3. Lift the trim plate and turn sideways in order to lift the trim plate over the transaxle shift lever.
4. Remove the trim plate from the front floor console.



Installation Procedure

1. Align the trim plate to the front floor console.
2. Position the trim plate over the transaxle shift lever.
3. Install the trim plate to the front floor console and snap into place.





Notice: Refer to Fastener Notice in Cautions and Notices.

4. Install the rear trim plate screw and insert the cup holder liner.

Tighten the screw to 2 N.m (18 lb in).