Fog/Driving Lamp: Service and Repair
FOG LAMP REPLACEMENT - FRONTREMOVAL PROCEDURE
CAUTION: Refer to Halogen Bulb Caution in Service Precautions.
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the electrical connector from the fog lamp.
3. Remove the nuts from the fog lamp.
4. Remove the fog lamp from the front bumper fascia.
5. Remove the fog lamp bulb from the fog lamp, turning counterclockwise, if required.
INSTALLATION PROCEDURE
1. Install the fog lamp bulb to the fog lamp, turning clockwise, if required.
2. Install the fog lamp to the front bumper fascia.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the fog lamp nuts to the fog lamp.
Tighten
Tighten the fog lamp nuts to 10 N.m (89 lb in).
4. Connect the electrical connector to the fog lamp.
5. Lower the vehicle.
6. Check and adjust the fog lamp aim as necessary. Refer to Fog Lamp Aiming Procedure.