Turn Signal Lamp: Service and Repair
PARK/TURN SIGNAL LAMP REPLACEMENTREMOVAL PROCEDURE
1. Open the hood.
2. Remove the screws from the front parking/sidemarker lamp.
3. Disconnect the front parking/sidemarker lamp wiring harness from the pinch-weld flange.
4. Remove the front parking/sidemarker lamp from the front fender.
5. Remove the front parking/sidemarker lamp socket, depressing the locking tab and turning counterclockwise.
6. Remove the bulb from the front parking/sidemarker lamp socket, if replacing the bulb.
INSTALLATION PROCEDURE
1. Install the bulb to the front parking/sidemarker lamp socket, if replacing the bulb.
2. Install the front parking/sidemarker lamp socket, turning the socket clockwise until the locking tab is fully seated.
3. Connect the front parking/sidemarker lamp wiring harness to the pinch-weld flange.
4. Align the ball stud of the front parking/sidemarker lamp to the grommet in the fender reinforcement.
5. Position the alignment pins of the front parking/sidemarker lamp to the to the holes in the fender reinforcement.
6. Install the front parking/sidemarker lamp to the front fender, pressing into place until fully seated.
NOTE: Refer to Fastener Notice in Service Precautions.
7. Install the screws to the front parking/sidemarker lamp.
Tighten
Tighten the front parking/sidemarker lamp screws to 2 N.m (18 lb in).
8. Close the hood.