Operation CHARM: Car repair manuals for everyone.
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Wiper Motor Replacement

TOOLS REQUIRED
- J 39232 Wiper Transmission Separator
- J 39529 Wiper Transmission Installer

REMOVAL PROCEDURE
1. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.




2. Disconnect the wiper motor electrical connector.
3. Remove the screws from the wiper drive system module.
4. Remove the wiper drive system module from the vehicle.




5. Using J 39232 , disconnect the transmission from the wiper motor crank arm.




6. Remove the wiper motor screws.
7. Remove the wiper motor from the wiper drive system module.

INSTALLATION PROCEDURE




1. Position the wiper motor to the wiper drive system module.
2. Install the wiper motor screws.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the screws to 10 N.m (89 lb in).




3. Using J 39529 , connect the wiper transmission arms to the wiper motor crank arm.

IMPORTANT: The motor crank arm pivot is a greased joint to the wiper transmission.




4. Position the wiper drive system module to the vehicle.
5. Install the wiper drive system module screws.

Tighten
Tighten the screws to 10 N.m (89 lb in).

6. Connect the wiper motor electrical connector.
7. Install the air inlet grille panel.
8. Inspect the wipers for proper operation.