Emblem/Nameplate Replacement - Door (Aztek)

Emblem/Nameplate Replacement - Door (Aztek)

Tools Required

J 25070 Heat Gun


Removal Procedure


Important: Use the tape for protection and alignment marks for alignment of the new emblem.


1. Apply tape to the area around the door emblem.
2. Heat the emblem/nameplate, using a heat gun J 25070 152 mm (6.0 in) from the surface.
3. Apply the heat using a circular motion for about 30 seconds.

Notice: Refer to Exterior Trim Emblem Removal Notice in Cautions and Notices.

4. Remove the emblem/nameplate from the door surface using a plastic, flat-bladed tool.




5. Remove all adhesive from the door panel surface and the back of the emblem/nameplate using 3M(TM) scotch brite molding adhesive remover disk 3M(TM) P/N 07501 or equivalent.
6. Clean the door surface using varnish makers and painters (VMP) naptha.



Installation Procedure





1. If the location of the emblem/nameplate has not been marked apply tape and use the following dimensions:

* Dimension (a) is 41 mm (1.625 in) from the rear door edge to the emblem/nameplate.
* Dimension (b) is 146 mm (5.750 in) from the feature line on the door to the bottom of the emblem/nameplate.

2. Warm the door surface with a heat gun J 25070 152 mm (6.0 in) from the surface to a minimum of 21°C (70°F).

Important: Do not touch the adhesive backing of the emblem/nameplate.


3. Remove the backing from the front end of the emblem/nameplate.
4. Press the emblem/nameplate to the door panel surface while continuing to remove the backing.
5. Hand roll the emblem/nameplate to the door panel to ensure proper adhesion.
6. Inspect the emblem/nameplate for bonding.
7. Remove the tape from the area around the door emblem.