Strut Replacement - Endgate

Strut Replacement - Endgate

Removal Procedure

Caution: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.






1. Open the endgate.

Notice: Refer to Liftgate/Hood Assist Rod Notice in Cautions and Notices.

2. Lift up the retainer clips on the endgate assist rods using a small flat-bladed tool.




3. Remove the upper end of the assist rods from the ball joint.




4. Remove the lower end of the assist rods from the ball joint.




5. Remove the assist rods from the endgate.



Installation Procedure





1. Position the assist rods to the endgate.




2. Install the upper end of the assist rods to the ball joint. Press in to place until fully seated.




3. Install the lower end of the assist rods to the ball joint. Press in to until fully seated.
4. Close the endgate.