Fuel Hose/Pipes Replacement - Engine Compartment

FUEL HOSE/PIPES REPLACEMENT - ENGINE COMPARTMENT

REMOVAL PROCEDURE
1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure.
2. Disconnect the engine fuel feed pipe from the chassis fuel flex hose.




3. Disconnect the engine fuel feed pipe from the Fuel Rail.
4. Remove the two fuel feed pipe fasteners.
5. Remove the engine fuel feed pipe.

INSTALLATION PROCEDURE




1. Install the fuel feed pipe to the fuel rail.
2. Install the engine fuel feed pipe fasteners located on the engine.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the fuel feed pipe fasteners to 10 N.m (89 lb in).

3. Connect the engine fuel feed pipe to the chassis fuel flex hose.
4. Connect the negative battery cable.
5. Inspect for leaks using the following procedure:
1. Turn ON the ignition, with the engine OFF for 2 seconds.
2. Inspect for fuel leaks.
3. Turn OFF the ignition for 10 seconds.
4. Turn ON the ignition.