Operation CHARM: Car repair manuals for everyone.
Home >> Pontiac >> 2006 >> G6 V6-3.9L VIN 1 >> Repair and Diagnosis >> Restraints and Safety Systems >> Air Bag Systems >> Air Bag Control Module >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Air Bag Control Module: Service and Repair



INFLATABLE RESTRAINT SENSING AND DIAGNOSTIC MODULE REPLACEMENT

REMOVAL PROCEDURE
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 8.

CAUTION: Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make sure that it is securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.

2. Remove the console.
3. Remove the automatic transmission shift control, if equipped.
4. Remove the park brake lever assembly.
5. Remove the inflatable restraint sensing and diagnostic module nuts.
6. Remove the inflatable restraint sensing and diagnostic module wire harness connector.




7. Remove the inflatable restraint sensing and diagnostic module.

INSTALLATION PROCEDURE
1. Point the arrow on the SDM toward the front of the vehicle.




2. Install the inflatable restraint sensing and diagnostic module.
3. Install the inflatable restraint sensing and diagnostic module wire harness connector.
4. Install the inflatable restraint sensing and diagnostic module nuts.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the nuts to 10 N.m (89 lb in).

5. Install the automatic transmission shift control, if equipped.
6. Install the park brake lever assembly.
7. Install the console.
8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 8 in Restraint Systems.

IMPORTANT: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring the SDM part number to be set in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check and follow the steps thoroughly to ensure that the SDM is set properly. Refer to Control Module References in Computer/Integrating Systems. Programming and Relearning

9. Program the inflatable restraint sensing module after replacement. Refer to Control Module References. Programming and Relearning
pro multis · About Operation CHARM