Battery Cable: Service and Repair

Battery Negative Cable Disconnection and Connection

Removal Procedure

Caution: Refer to Restraint System Service Precautions.




1. Remove the rear compartment trim panel.
2. Record all of the vehicle preset radio stations.
3. Ensure that all lamps and accessories are OFF.
4. Ensure that the ignition switch is in the OFF position.

Caution: Refer to Battery Disconnect Caution.

5. Loosen the negative battery cable (2) bolt.
6. Remove the negative battery cable (3) from the battery.

Installation Procedure






Important: Clean any existing oxidation from the contact face of the battery terminal and battery cable using a wire brush before installing the battery cable to the battery terminal.

1. Position the negative battery cable (3) to the battery.

Notice: Refer to Fastener Notice.

2. Tighten the negative battery cable bolt (2).

Tighten the bolt to 17 N.m (13 lb ft).

3. Install the rear compartment trim panel.
4. Reset the radio stations and the clock.