Oil Pump Drive Replacement

Oil Pump Drive Replacement

Removal Procedure

1. Remove the lower intake manifold.




2. Remove the oil pump drive clamp bolt.
3. Remove the oil pump drive clamp.
4. Remove the oil pump drive.

Installation Procedure




1. Apply prelube GM P/N 12345501 (Canadian P/N 992704) or the equivalent to the oil pump drive gear.
2. Apply engine oil to the oil pump drive gear assembly for ease of assembly.
3. Install the oil pump drive gear assembly.
4. Install the oil pump drive gear clamp.

Notice: Refer to Fastener Notice .

5. Install the oil pump drive gear clamp bolt.

Tighten the bolt to 36 N.m (27 lb ft).

6. Install the lower intake manifold.