Fuel Filler Hose: Service and Repair

FILLER TUBE REPLACEMENT

REMOVAL PROCEDURE

1. IMPORTANT: Replacement fuel filler tube hoses do not come equipped with hose clamps. Obtain replacement hose clamps prior to beginning this service procedure.

CAUTION: Do not allow smoking or the use of open flames in the area where work on the fuel or EVAP system is taking place. Anytime work is being done on the fuel system, disconnect the negative battery cable, except for those tests where battery voltage is required.

Ensure that the fuel level in the tank is less than 1/4 full. If necessary, drain the fuel tank to at least this level. Refer to Fuel Tank Draining .

3. Raise and support the vehicle. Refer to Vehicle Lifting .
4. Remove the right rear wheel and tire.
5. Remove the right rear wheelhouse inner liner.




6. Loosen the fuel filler tube hose clamp.
7. Disconnect the fuel filler tube, the fuel filler vent tube, and the fresh air hose from the fuel tank.




8. Remove the fuel filler tube bracket bolts (2).




9. Remove the fuel filler tube (1) from the vehicle.




10. Remove the closeout grommet.




11. Separate the fresh air hose from the fuel filler tube.

INSTALLATION PROCEDURE




1. Attach the fresh air hose to the fuel filler tube.




2. Install the closeout grommet.




3. Position the fuel filler tube (1) to the vehicle.




4. Position the fuel filler tube to the closeout grommet (1).

5. NOTE: Refer to Fastener Notice .

Install the fuel filler tube bracket bolts (2).

Tighten the bolt to 12 N.m (106 lb in).




6. IMPORTANT: Ensure that the fuel filler tube connecting hose is installed until it touches the fuel tank body. The hose clamp should be located within 13 mm (1/2 in) of the end of the connecting hose.

Position the filler tube-to-fuel tank connecting hose and hose clamp.

Tighten the clamp to 5 N.m (44 lb in).

7. Connect the fuel filler vent tube and fresh air hose.
8. Install the inner wheelhouse liner.
9. Install the wheel and tire.
10. Lower the vehicle from the hoist.
11. Install the fuel filler cap.
12. Perform the Service Bay Diagnostic Test for the EVAP emission system using the scan tool. This test will verify the integrity of the vapor handling areas of the fuel system. Service Bay Test