1-2-Reverse Clutch Plate Disassemble

1-2-Reverse Clutch Plate Disassemble

Special Tools
* J-23327 - Clutch Spring Compressor
* J-28585 - Snap Ring Remover
* J-23456 - Booster and Clutch Pack Compressor
* J-45184 - Differential Bearing Race Installer




1. Remove the 1-2 reverse clutch backing plate retaining ring (622) using J-28585 - remover.
2. Remove the following components:

* The 1-2 reverse clutch backing plate (621)
* The 6 1-2 reverse clutch fiber plates (620)
* The 6 1-2 reverse clutch steel plates (619)
* The 1-2 reverse clutch apply plate (618)





Note: Do not bend the 1-2 reverse clutch piston return spring assembly (601).

3. Place J-45184 - installer (1) on the center of J-23456 - compressor (2).
4. Place the transmission case cover (19) with the 1-2 reverse clutch piston assembly onto J-45184 - installer (1).
5. Using J 23327-1 (3), which is the bridge part of J-23327 - compressor , compress the 1-2 reverse clutch piston return spring assembly (601).
6. Remove the 1-2 reverse clutch piston return spring retaining ring (600) using snap ring pliers.
7. Remove the pressure from J-23456 - compressor (2), remove J 23327-1 (3) and the 1-2 reverse clutch piston return spring assembly (601).
8. Remove all tools.





Warning

Wear safety glasses when using compressed air in order to prevent eye injury.

9. While pulling upward on the piston by hand, apply compressed air into the 1-2 reverse clutch fluid passage and remove the 1-2 reverse clutch piston (603).
10. Remove the 1-2 reverse clutch piston inner seal (602).
11. Remove the 1-2 reverse clutch piston outer seal (604).