Manifold Pressure/Vacuum Sensor: Service and Repair

Manifold Absolute Pressure Sensor Replacement

Removal Procedure

1. Disconnect the manifold absolute pressure (MAP) sensor electrical connector.




2. Remove the MAP sensor retaining bolt (3) and bracket (2).
3. Remove the MAP sensor (1) and the MAP sensor port seal if it is still retained in the intake manifold.

Installation Procedure




1. Install the MAP sensor (1) to the intake manifold.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the MAP sensor retaining bracket (2) and bolt (3).

Tighten the bolt to 10 Nm (89 lb in).

3. Connect the MAP sensor electrical connector.