Camshaft Position Sensor: Service and Repair

Camshaft Position Sensor Replacement

Removal Procedure




1. Remove the air cleaner inlet duct. Refer to Air Cleaner Inlet Duct Replacement (Service and Repair).
2. Disconnect the engine wiring harness electrical connector from the camshaft position (CMP) sensor.
3. Remove the CMP sensor bolt (2).
4. Remove the CMP sensor (1).
5. Inspect the CMP sensor O-rings for wear, cracks, or leakage if the sensor is being reused. Replace the O-rings if damaged.

Installation Procedure

1. Lubricate the CMP sensor O-rings with clean engine oil.




2. Install the CMP sensor (1).

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the CMP sensor bolt (2).

Tighten the bolt to 10 Nm (89 lb in).

4. Connect the engine wiring harness electrical connector to the CMP sensor.
5. Install the air cleaner inlet duct. Refer to Air Cleaner Inlet Duct Replacement (Service and Repair).