Output Speed Sensor Replacement

Output Speed Sensor Replacement

Removal Procedure

1. Remove the battery tray. Refer to Battery Tray Replacement (Battery Tray Replacement).




2. Disconnect the electrical connector (2) from the output shaft speed sensor.




3. Remove the output speed sensor bolt.
4. Remove the output shaft speed sensor and the O-ring.

Installation Procedure




1. Apply GM T-IV automatic transaxle fluid GM P/N 88900925 to the new output speed sensor O-ring.
2. Install the new output speed sensor O-ring onto the output speed sensor (2).
3. Install the output speed sensor into the transmission case assembly.

Caution: Refer to Fastener Caution (Fastener Caution).

4. Install the output speed sensor bolt and tighten to 5 Nm (44 lb in).




5. Connect the electrical connector (2) to the output shaft speed sensor.
6. Install the battery tray. Refer to Battery Tray Replacement (Battery Tray Replacement).