Transmission Position Sensor/Switch: Service and Repair

1. Set parking brake, then place transmission selector lever in the Neutral position.
2. Remove transmission under body cover.

Selector Cable & Actuating Lever:

3. Disconnect transmission selector cable from selector lever, Fig. 3.
4. Remove nut and washer, then remove selector lever from shaft.
5. Unlatch switch electrical connector holder, then disconnect switch electrical connector.
6. Remove switch attaching screws, then remove the switch.
7. Reverse procedure to install. Torque switch attaching screws to 7.4 ft. lbs. Torque actuator shaft retaining nut to 11 ft. lbs. After completing installation, check selector cable adjustment, as describer under ``Selector Cable, Adjust.''