Without Tiptronic Transmission

1. Remove right-hand rear wheel and take off right heater hose from heat exchanger.

2. Remove sender. Undo upper M 6 x 16 pan head screw.

3. Align flywheel. Rotate crankshaft or flywheel, respectively, and align a tooth of the flywheel to the center of the sender housing.

4. Determine the clearance between the spacers and the toothed head using a depth gauge. Record the value determined.

5. Measure plug-in depth of Determine plug-in depth on the removed sender, using the sender a depth gauge. Record the value determined.

Determine actual value
Example:
Dimension from spacers to toothed head 24.7 mm
Sender plug-in depth - 24.0 mm
Difference 0.7 mm

The difference between the depth value and the sender plug-in depth must be 1 ±0.2 mm.
In this case, insert a spacer with a thickness of 0.1 mm to achieve the specified value.

4. Establishing the specified value: 1 ±O.2 mm
To achieve the specified value, spacers available in thicknesses of 0.1 mm and 0.4 mm from the spares department may be used.

5. Correct setting. Undo bottom M 6 x 16 pan head screw and correct spacer thickness according to the dimension determined.

Note: When making a new setting, try to achieve a difference of 1.0 mm.