Cap For Selector Force Mechanism

Tools





Removing and installing cap for selector force mechanism

Removal
1. Remove transmission.





2. Shift transmission to neutral, unscrew fastening screw "A" and remove snap ring "B".





3. Bore a 3.5 mm large hole into the center of the closure cap (coat drill with viscous grease to prevent drilling chips from falling into the transmission). Screw in a sheetmetal screw (4.8 x 25) with a large washer and lever out the closure cap using two screwdrivers.

Installation
1. Insert closure cap and snap ring into the housing bore.
2. Use special tool P375 to push the snap ring and closure cap down until the snap ring engages into the groove.

Note Ensure perfect seating of the snap ring.

3. Tighten the fastening screw for the wheel bearing housing to 25 Nm (19 ft. lbs.).
4. Install transmission.