Transmission Position Sensor/Switch: Service and Repair

Removing and installing multi-function switch
Removal





1. Unclip, release and disconnect cable connection to the multi-function switch.





2. Remove ATF line. Collect emerging ATF at the same time.





3. Unscrew fastening screws and pull switch off the selector shaft.

Installation





1. Put multi-function switch on the selector shaft. The flat point on the serrations in the switch "A" must lie against the flat point on the selector shaft "B".

Note: Place multi-function switch on the selector shaft. Do not tilt or use force: you may damage the switch contacts.

2. Turn switch until the fitting bore on the switch housing can be put on the dowel pin on the transmission housing.
3. Replace sealing rings for ATF line and install ATF line.




Tightening torques