Crankshaft Position Sensor: Service and Repair

Removal
1. Remove right rear wheel.
2. Disconnect plug connection; to do this, press the clip and simultaneously pull off the plug.
Pull the lower plug half out of the holder to the right.







3. Unclip cable (arrow 1).
Undo M6 x 16 pan-head screw (arrow 2) (wrench size 4 mm) and remove the pulse sender.







Installation
1. Install pulse sender.
Tightening torque of the pan-head screw (M6x16): 10 ± 0.5 Nm (7.5 ± 0.5 ft. lbs.)
2. Push in lower plug half on the holder.
3. Push plug on until it audibly engages.