Headlamp Alignment Control Module: Service and Repair

Removing And Installing Module For Automatic Headlight Beam Adjustment

NOTE: The control module is fitted on the right-hand side of the dashboard under the passenger airbag unit.

Removal
1. Remove footwell bulkhead and right air guide.
2. Undo the control module (two sheetmetal screws) from below. Release the electrical plug connection and take out the control module.







Installation
1. Engage the electrical plug connection and fasten the control module to the bracket.
2. Install the right-hand air guide and footwell bulkhead.
3. After installation, the control module must be encoded and calibrated with the Porsche System Tester 2. After this, the headlights must be readjusted using a standard 5 mm ball-head screwdriver.