Removing and Installing Control Module For Gas Discharge Lamp

Removing And Installing Control Module For Gas Discharge Lamp

WARNING: Warning signs (yellow triangle with black high-voltage arrow) indicate high voltage (risk of fatal injury).
- The light must always be switched off when removing and installing these components (control module, ignition unit, gas discharge lamp, servo motor). Once removed, a headlight is not under high voltage.
- The gas discharge lamp (D2S lamp) may only be operated when installed in the reflector and with the headlight installed.

Removal
1. Switch off the light. Release the headlight housing and pull out forwards slightly.
2. Disconnect the electrical plug connection of the automatic headlight beam adjustment and remove the headlight housing.
3. Release and open the cover with control module. Disconnect the electrical plug connection from the control module and undo the three fastening screws.







4. Remove the control module from the cover.

Installation
1. Attach a new control module to the cover and engage the electrical plug connection.
2. Lock the cover with control module and insert the headlight housing in the wing.
3. Engage the electrical plug connection of the automatic headlight beam adjustment and lock the headlight housing in the wing.
4. Carry out function check of the headlights.