Knock Sensor: Service and Repair
WM 287219 Removing and installing knock sensor
Preliminary work
1. Remove the thermostat housing for both front knock sensors (sensor for cylinders 1 and 2 as well as sensor for cylinders 5 and 6) -> 195519 Removing and installing housing for coolant regulator - section on "Removing" Service and Repair.
2. Remove the starter for both rear knock sensors (sensor for cylinders 3 and 4 as well as sensor for cylinders 7 and 8) -> 276019 Removing and installing starter - section on "Removing" 276019 Removing and Installing Starter.
Removing knock sensor
1. Observe and note installation position of knock sensors.
Pull off cable plugs -a- ( -arrow- ). => Pulling off cable plug
Pulling off cable plug
2. Unscrew fastening screw -2- and remove knock sensor -1- from the crankcase.
Knock sensors
Installing knock sensor
Information
The tightening specifications for the basic engine are stored centrally. -> 1001IN Tightening torques, tightening sequences, assembly overviews [1][2]Specifications. Tightening torques and assembly instructions for other affected assemblies (e.g. chassis, electrics, transmission or body) or for peripheral engine equipment can be found in the corresponding documents.
Information
- Clean contact surface of knock sensor with a cloth.
1. Install knock sensors -1-. Make sure that the knock sensors are aligned as shown in the illustration.
Knock sensors
Information
Strictly observe the specified tightening torque for the knock sensor screw. Align the housing and cable plug for the knock sensor in such a way that they are not touching. Otherwise, there is no guarantee that the knock sensor will work perfectly.
2. Tighten fastening screws -2- ().
3. Push on cable plug.
Subsequent work
1. Install the thermostat housing for both front knock sensors (sensor for cylinders 1 and 2 as well as sensor for cylinders 5 and 6) -> 195519 Removing and installing housing for coolant regulator - section on "Installing" Service and Repair.
2. Install the starter for both rear knock sensors (sensor for cylinders 3 and 4 as well as sensor for cylinders 7 and 8) -> 276019 Removing and installing starter - section on "Installing" 276019 Removing and Installing Starter.