Front

Removal
1. Unplug the sensor lead connector (one for each wheel) in the engine bay by pushing the halves together to release the catches.





On the LH side:
- Lift the rubber moulding on the bulkhead panel.
Remove the cover over the space behind the bulkhead panel.
Undo the plastic clip at the panel.





On the RH side:
a) Lift the rubber moulding on the bulkhead panel.
Remove the cover over the space behind the bulkhead panel.
Undo the plastic clip at the panel.
b) Raise the AC pipes and pull the sensor lead through.
2. Raise the car and remove the front wheel (or wheels).
3. Remove the rear section of the wing liner.





4. Snip through the cable tie securing the sensor lead to the top bracket.
- Pull the sensor lead through the rubber grommet in the wheel housing.





5. Undo the securing bolt and remove the sensor.


Installation





1. Install the sensor, tightening the securing bolt.
2. Pass the sensor lead through the rubber grommet in the wheel housing and secure it in the brackets.
- Install a cable tie around the top one.
3. Plug the lead into the connector in the engine bay.
- Reinstall the components that have been removed.
4. Reinstall the wing liner.
5. Reinstall the front wheel or wheels.
- Turning the steering from lock to lock, check that the sensor lead cannot rub against any front- assembly components.