Installation

1. Install the antifreeze thermostat and plug in the connector.
2. Connect the anti-freeze thermostat's sensor to the low-pressure pipe, using the clip.
3. Refit the cover on the climate control unit and tighten the screws. Run the ventilation fan at maximum speed and check that condensate does not leak out from the evaporator. If necessary install a new gasket between the end cover and climate control unit.
4. Tighten the nuts securing the antifreeze thermostat.
5. Refit the fan control unit and tighten the screws (cars with ACC).
6. Refit the protective cover.
7. Plug in the dashboard wiring. Secure the wiring by means of cable ties.
8. Cars with automatic transmission:
- Screw the bracket for the automatic transmission control module to the bulkhead wall.
- Install the control module in the bracket.
9. Install the air duct to the dashboard's side vent.
10. Refit the floor ducts.
11. Cars with an airbag on the passenger's side: Refit the knee guard and tighten the screws.
12. Refit the centre console's side panel.
13. Refit the glove box and tighten the retaining screws.