Fuel Filter: Service and Repair

REMOVING AND INSTALLING FUEL FILTER

WARNING Removal of the fuel filter involves partial dismantling of the car's fuel system. The following points must therefore be observed in connection with this work:

- Work only in a well-ventilated area. If approved equipment for the extraction of fuel vapor is available, be sure to use it.

- Wear suitable gloves. Prolonged contact with fuel may give rise to skin irritation or dermatitis.

- Keep a class BE fire extinguisher near at hand. Be mindful of the danger of sparks caused by short-circuits and when connecting and disconnecting leads, etc. in electrical circuits.

- No smoking anywhere in the vicinity.

To Remove;






1. Drain all fuel from the filter before removing it.






2. Undo the banjo fittings on both sides of the filter.

3. Undo the filter clamp.

4. Remove the filter.


To Fit:

Fit in reverse order.

Tightening torque for banjo fittings: 21 Nm (16 ft. lbs.).



Important

Fit new sealing washers before fitting.