Input Shaft Speed Sensor

Removal
1. Turn the expansion tank aside.
2. Remove the sensor's screw,
3. Raise the car.
4. Remove the left-hand front wheel.
5. Inch out the sensor.
6. Unplug the electrical connector.

Installing
1. Plug in the sensor connector in place.
2. Refit the front wheel.
Tightening torque:
- 100 Nm (74 ft lbs) pressed steel wheel.
- 120 Nm (89 ft lbs) light alloy wheel.
Lower the car.
3. Tighten the sensor's screw.
- Tightening torque: 6 Nm (4.5 ft lbs).
4. Refit the expansion tank.