Theft Alarm Basic Programming

The theft alarm control module has a basic program from the supplier. EOL programming is then carried out in the factory. This cannot however meet the requirements of all countries which means that further programming must be done at delivery service, see the table on the next page. When changing a control module, the alarm must be programmed as spare part programming, see the table below.

Instructions and descriptions of the functions are in charts below. Where there is no cross in the tables, the unit is pre-programmed from the supplier.


Important : If new values are programmed at the request of a customer or for any other reason, it is up to the mechanic to make sure that these do not break any laws or insurance requirements that might apply.







Programming at delivery service







Programming spare part