Throttle Position Sensor: Service and Repair

To Remove
1. Remove the resonating chamber.
2. Disconnect the crankcase breather hose and the Idle Air Control (IAC) valve with hoses.
3. Unplug the connector, remove the two retaining screws and remove the sensor. Note the O-ring.

To Install
1. Make sure that the O-ring is correctly positioned and install the sensor on the throttle spindle. Tighten the retaining screws.
2. Plug in the connector, refit the IAC valve with hoses and reconnect the crankcase breather hose.
3. Refit the resonating chamber.