Programming For Siren

In the basic version, only the alarm's special horn is used for the sound alarm. However, in certain markets the fitting of a siren with battery back-up is required. The alarm's horn is activated via a relay output in the electronic control module, that is to say the horn is activated by being grounded. The siren must be supplied continuously with +12 V and if this 12 V supply is interrupted, the siren will start. To accomplish this, the alarm must be programmed for the siren. For it to work correctly, the siren must be selected in the "COUNTRY CODE" menu. See "COUNTRY CODE" programming. Alarm Signal, Country-Specific/Own Alternative/Siren

Programming
Connect an Intelligent Saab Tester (ISAT) scan tool.
Select "PROGRAMMING".
Select "SIREN" and then:
1 "ON" if the siren is to be included.
2 "OFF" if the siren is not to be included.


Important: IF "ON" is selected, sound confirmation will not be available.