Theft Alarm Basic Programming

Basic programming of the anti-theft alarm's electronic control module is carried out by the supplier. Subsequently, EOL programming is carried out at the factory. However, since this cannot meet the needs of all countries, additional programming has to be carried out in connection with pre-delivery service, see table below. In the event of electronic control module replacement, the anti-theft alarm must be programmed in accordance with spare part programming, see table below.


Important: If new values are programmed at the request of a customer or for any other reason, it is up to the mechanic to make sure that these do not break any laws or insurance stipulations that might be applicable.







O = Function programmed at factory
X = Reprogramming to be carried out in connection with pre-delivery service.







O = Function programmed at factory
X = Reprogramming to be carried out for spare part.