Air Bag Control Module: Service and Repair

WARNING:Read through the Safety and handling instruction before starting work.




Removal
1. Disconnect the negative battery lead
2. Remove the carpet on the center console on the passenger side.
3. Remove the three control module securing screws.
4. Unplug the connector from the control module.

- Fitting is in reverse order.

Tightening torque, control module: 9 Nm (6.6 ft lb).

- Connect ISAT to the data link connector and program in the number of airbags that the car is equipped with. Erase any diagnostic trouble codes.

- Switch on the ignition and wait for at least 10 seconds with the ignition on. Check that the SRS lamp lights for 3-4 seconds and then goes out. Check that the SRS lamp does not show any fault (stays lit). Disconnect the ISAT